The reason sinks are so useful is because they already have a hole in the bottom of them that act as the drain.
The legs should be high enough off the ground so that the forge itself is about hip-high.
Wear gloves and goggles during this part of the process as well.
You can pick up a shop vacuum, which supplies the air for the fire, at any home improvement store or buy one online.
You can pick up cement at a local home improvement store or order some online.
The two reducers can also be 0. 75 inches (1. 9 cm) in width.
Make sure the body of the burner is completely still when you hit it with the hammer. Otherwise, the hole is going to end up in the wrong place.
Clear all the extra metal shaving off your work table before you move on to the next step.
The reason you put the pipe in the burner at first is to see if it fits tightly.
Make sure to center-punch the hole on the pipe like you did for the burner.
If the pipe is spinning in the burner and doesn’t fit tightly enough, you can add wrap some wire around the end cap to keep it from moving.
You can use a 0. 125 in (0. 32 cm) bushing if you’d like.
